3D-Architecture and Neogene Evolution of the Malatya Basin: Inferences for the Kinematics of the Malatya and Ovacık Fault Zones

NURETDİN KAYMAKCI; Murat İnceöz & Pinar ERTEPINAR

Makale detayları

3D-Architecture and Neogene Evolution of the Malatya Basin: Inferences for the Kinematics of the Malatya and Ovacık Fault Zones

Yazarlar:

NURETDİN KAYMAKCI | Murat İnceöz & Pinar ERTEPINAR

Yayıncı:

TUBITAK

Dergi:

Turkish Journal of Earth Sciences 2006 Vol.15 Issue 2, pp.123-154

Belge Tipi:

Makale

Yayın Tarihi:

1/2006

Belge Dili:

Türkçe

Document ID (Org No.):

2000732695

Sıklık:

İki Aylık

eISSN:

1303-619X

pISSN:

1300-0985

Özet:

 

The 3D-architecture of the Malatya Basin was studied using remote sensing, seismic interpretation, and palaeostress analysis in the context of the Malatya-Ovacık fault zone. The results indicate that the Ovacık and Malatya fault zones are not different segments of a single 'so called' Malatya-Ovacık fault zone; rather, they are two different fault zones that have operated independently. In addition, the Ovacık fault zone is delimited in the west by the Malatya fault zone, which extends farther north from the point of supposed junction. Maximum individual deflection of streams along the Ovacık fault zone is about 9.3 km, and summation of all stream deflections along different segments of the Ovacık fault zone indicates that sinistral displacement of the Ovacık fault zone has been not more than 20 km following development of the drainage system in the region.   Evidence for three different deformation phases were recognized in the Malatya Basin. Deformation phase 1 was characterized by NW-SE-directed extension and operated in the Early to Middle Miocene interval. Deformation phase 2 was characterized by WNW-ESE-directed compression and a vertical s2 which indicates transcurrent tectonics. It operated in the Late Miocene to Middle Pliocene. Deformation phase 3 was characterized by NNE-SSW-directed compression, and vertical stress is interchanged with s2 and s3; this is interpreted as due to near equal magnitudes of these stresses, resulting in stress permutation and interchange of intermediate and minor stress. Deformation phase 3 commenced in the Late Pliocene and has been active since then.   The infill of the Malatya Basin has wedge-like geometry in E-W and N-S directions and the basin fed detritus mainly from its eastern margin. During field studies in the basin, a number of inverted normal faults were encountered; these apparently developed as growth faults in the Early to Middle Miocene time interval and then were reactivated or inverted during post-Middle Miocene compressional phases.

 

The 3D-architecture of the Malatya Basin was studied using remote sensing, seismic interpretation, and palaeostress analysis in the context of the Malatya-Ovacık fault zone. The results indicate that the Ovacık and Malatya fault zones are not different segments of a single 'so called' Malatya-Ovacık fault zone; rather, they are two different fault zones that have operated independently. In addition, the Ovacık fault zone is delimited in the west by the Malatya fault zone, which extends farther north from the point of supposed junction. Maximum individual deflection of streams along the Ovacık fault zone is about 9.3 km, and summation of all stream deflections along different segments of the Ovacık fault zone indicates that sinistral displacement of the Ovacık fault zone has been not more than 20 km following development of the drainage system in the region.   Evidence for three different deformation phases were recognized in the Malatya Basin. Deformation phase 1 was characterized by NW-SE-directed extension and operated in the Early to Middle Miocene interval. Deformation phase 2 was characterized by WNW-ESE-directed compression and a vertical s2 which indicates transcurrent tectonics. It operated in the Late Miocene to Middle Pliocene. Deformation phase 3 was characterized by NNE-SSW-directed compression, and vertical stress is interchanged with s2 and s3; this is interpreted as due to near equal magnitudes of these stresses, resulting in stress permutation and interchange of intermediate and minor stress. Deformation phase 3 commenced in the Late Pliocene and has been active since then.   The infill of the Malatya Basin has wedge-like geometry in E-W and N-S directions and the basin fed detritus mainly from its eastern margin. During field studies in the basin, a number of inverted normal faults were encountered; these apparently developed as growth faults in the Early to Middle Miocene time interval and then were reactivated or inverted during post-Middle Miocene compressional phases.

Makale detayları

3D-Architecture and Neogene Evolution of the Malatya Basin: Inferences for the Kinematics of the Malatya and Ovacık Fault Zones

Yazarlar: NURETDİN KAYMAKCI | Murat İnceöz & Pinar ERTEPINAR

Yayıncı: TUBITAK

Dergi: Turkish Journal of Earth Sciences 2006 Vol.15 Issue 2, pp.123-154

Belge Tipi: Makale

Yayın Tarihi: 1/2006

Belge Dili: Türkçe

Document ID (Org No.): 2000732695

Sıklık: İki Aylık

eISSN: 1303-619X

pISSN: 1300-0985

Sayı

Yazarlar:

NURETDİN KAYMAKCI | Murat İnceöz & Pinar ERTEPINAR

Yayıncı:

TUBITAK

Dergi:

Turkish Journal of Earth Sciences 2006 Vol.15 Issue 2, pp.123-154

Belge Tipi:

Makale

Yayın Tarihi:

1/2006

Belge Dili:

Türkçe

Document ID (Org No.):

2000732695

Sıklık:

İki Aylık

eISSN:

1303-619X

pISSN:

1300-0985