The Effects of The Use of E-B Diesel Fuels on Engine Lubricating Oil in Single Cylinder Diesel Engine

Fatih AYDIN; Hüseyin ÖĞÜT

doi:https://doi.org/10.18245/ijaet.438116

Makale detayları

The Effects of The Use of E-B Diesel Fuels on Engine Lubricating Oil in Single Cylinder Diesel Engine

Yazarlar:

Fatih AYDIN | Hüseyin ÖĞÜT

Yayıncı:

Murat CİNİVİZ

Dergi:

International Journal of Automotive Engineering and Technologies 2017 Vol.6 Issue 3, pp.129-139

Belge Tipi:

Makale

Yayın Tarihi:

11/2017

Belge Dili:

Türkçe

Document ID (Org No.):

2000476488

Sıklık:

Aylık

eISSN:

2146-9067

DOI:

https://doi.org/10.18245/ijaet.438116

Özet:

 

In this study, biodiesel was produced by turning the raw oil, obtained from safflower seed, into Safflower Oil Methyl Ester by means of transesterification method.  Mixing the biodiesel fuel, which was obtained from the safflower, with diesel fuel by adding bioethanol at the rate of 2.5% and 5% and volumetrically in inverse proportion, test fuels were acquired in the form of M100, E2.5B2.5M95, E5B5M90, E5B2.5M92.5 and E2.5B5M92.5.  The tests of the diesel fuel and the obtained mixture fuel were carried out related to the fuel features; kinematic viscosity, density, water content, pH level, determination of color, calorific value, flash point, clouding, pour and freezing point, copper bar corrosion test, iodine number, cold filter plugging point and cetane number. Also, the obtained mixture were tried and examined on a four-cycle, single cylinder and on water cooled diesel engine with direct injection fuel system. The engine ran for 100 hours under partial load and the samples were taken from the engine oil at specific times and wear elements were searched. As a result of the analysis of the samples taken from engine lubricating oil, it was observed that as the engine run time increased, the wear elements in the samples increased, too. As a result of ICP oil analysis, the amount of wear elements such as iron, copper, aluminum, lead and chromium in engine lubricating oil were stated diagrammatically. It was determined that the use of E2.5B5M92.5 produced better results than the other types of fuels in terms of wear elements.

Makale detayları

The Effects of The Use of E-B Diesel Fuels on Engine Lubricating Oil in Single Cylinder Diesel Engine

Yazarlar: Fatih AYDIN | Hüseyin ÖĞÜT

Yayıncı: Murat CİNİVİZ

Dergi: International Journal of Automotive Engineering and Technologies 2017 Vol.6 Issue 3, pp.129-139

Belge Tipi: Makale

Yayın Tarihi: 11/2017

Belge Dili: Türkçe

Document ID (Org No.): 2000476488

Sıklık: Aylık

eISSN: 2146-9067

DOI: https://doi.org/10.18245/ijaet.438116

Sayı

Yazarlar:

Fatih AYDIN | Hüseyin ÖĞÜT

Yayıncı:

Murat CİNİVİZ

Dergi:

International Journal of Automotive Engineering and Technologies 2017 Vol.6 Issue 3, pp.129-139

Belge Tipi:

Makale

Yayın Tarihi:

11/2017

Belge Dili:

Türkçe

Document ID (Org No.):

2000476488

Sıklık:

Aylık

eISSN:

2146-9067

DOI:

https://doi.org/10.18245/ijaet.438116