Analysis of Combustion and Cycle to Cycle Variations of an Ethanol (E100) Fueled Spark-Ignition Engine

Sachin Kumar GUPTA; K. A. SUBRAMANİAN

doi:https://doi.org/10.30939/ijastech..999559

Makale detayları

Analysis of Combustion and Cycle to Cycle Variations of an Ethanol (E100) Fueled Spark-Ignition Engine

Yazarlar:

Sachin Kumar GUPTA | K. A. SUBRAMANİAN

Yayıncı:

Otomotiv Mühendisleri Derneği

Ana Başlıklar:

Diğer mühendislik dalları

Dergi:

International Journal of Automotive Science And Technology 2022 Vol.6 Issue 1, pp.68-74

Belge Tipi:

Makale

Yayın Tarihi:

3/2022

Belge Dili:

İngilizce

Document ID (Org No.):

2000718807

Sıklık:

Üç Aylık

eISSN:

2587-0963

DOI:

https://doi.org/10.30939/ijastech..999559

Özet:

 

Ethanol, produced from biomass, is a renewable fuel that can be an attractive alternative fuel to gasoline for the increasing concerns of energy security and the environment. In the present work, combustion characteristics of ethanol (E100) fueled spark-ignition engine are compared with base gasoline fuel, and consecutively evaluated the cycle-to-cycle variations (CCV) of the engine parameters using statistical analysis. These investigations were performed on a 250cc air-cooled four-stroke single-cylinder port-fuel injection spark-ignition fueled with ethanol and gasoline fuels. The engine was operated at 3500 rpm and 4000 rpm of engine speed while maintaining the same loads for ethanol and gasoline. It was found from the results that the peak in-cylinder pressure (Ppeak) is lower with ethanol than gasoline at a given load. The Ppeak decreased from 27.5 to 25.5 bar when ethanol was used in the engine at 9.8:1 compression ratio, 3500 rpm, and 5 Nm load. Moreover, the mass fraction burned of the air-fuel mixture was faster for ethanol as compared to gasoline. The CCV with Ppeak, location of Ppeak, engine speed, and indicated mean effective pressure (IMEP) were evaluated. The result showed that CCV of Ppeak and its location were lowered for ethanol related to gasoline. A decrement in the coefficient of variation (COV) of Ppeak and its location from 11.6% to 8.3% and 12.6% to 11.7%, respectively, were observed when ethanol was utilized in the engine instead of gasoline at 3500 rpm and 5 Nm load. This resulted in a decrease in the COV of IMEP and engine speed by 2.8% and 0.25%, respectively, for ethanol as compared to gasoline at 3500 rpm and 5 Nm. This study results indicate the combustion stability of spark ignition engine with ethanol (E100) is better than gasoline fuel.

Makale detayları

Analysis of Combustion and Cycle to Cycle Variations of an Ethanol (E100) Fueled Spark-Ignition Engine

Yazarlar: Sachin Kumar GUPTA | K. A. SUBRAMANİAN

Yayıncı: Otomotiv Mühendisleri Derneği

Ana Başlıklar: Diğer mühendislik dalları

Dergi: International Journal of Automotive Science And Technology 2022 Vol.6 Issue 1, pp.68-74

Belge Tipi: Makale

Yayın Tarihi: 3/2022

Belge Dili: İngilizce

Document ID (Org No.): 2000718807

Sıklık: Üç Aylık

eISSN: 2587-0963

DOI: https://doi.org/10.30939/ijastech..999559

Sayı

Yazarlar:

Sachin Kumar GUPTA | K. A. SUBRAMANİAN

Yayıncı:

Otomotiv Mühendisleri Derneği

Ana Başlıklar:

Diğer mühendislik dalları

Dergi:

International Journal of Automotive Science And Technology 2022 Vol.6 Issue 1, pp.68-74

Belge Tipi:

Makale

Yayın Tarihi:

3/2022

Belge Dili:

İngilizce

Document ID (Org No.):

2000718807

Sıklık:

Üç Aylık

eISSN:

2587-0963

DOI:

https://doi.org/10.30939/ijastech..999559