Evaluation of the thermal efficiency of nanofluid flows in flat plate solar collector

N.A.

Makale detayları

Evaluation of the thermal efficiency of nanofluid flows in flat plate solar collector

Yazarlar:

N.A.

Yayıncı:

Yildiz Technical University

Ana Başlıklar:

Thermodynamics and Statistical Physics

Dergi:

Journal of Thermal Engineering Vol.10 Issue 2, pp.299-307

Belge Tipi:

Makale

Yayın Tarihi:

3/2024

Belge Dili:

İngilizce

Document ID (Org No.):

2001313850

pISSN:

2148-7847

Anahtar kelimeler:

Özet:

 In this research, flat plate solar collectors FPSC were studied due to their simplicity, low maintenance, and cost-effectiveness. The study focused on comparing FPSC thermal performance using CuOH2O nanofluids. Experiments were conducted over three months during the Iraqi weather conditions January, February, and March with carefully selected nanoparticle concentrations. Data was collected from 9 A.M. to 3 P.M., using various mass flow rates ranging from 0.003 to 0.076 kgs. Results showed a direct correlation between temperature and nanoparticle concentrations, with the highest outlet temperature 50C observed at 3 P.M. for 1 CuO-water nanofluid. Notably, at 1 P.M. in March, the 1 CuO-water nanofluid exhibited a 32 increase in collector thermal efficiency, surpassing pure water by 11.3. This would improve the performance of FPSC by achieving higher efficiency increments. These improvements were attributed to the unique physical properties of nanoparticles, their increased surface area, and higher thermal conductivity. The study determined that the optimum nanofluid concentration for superior collector efficiency was 1.

 In this research, flat plate solar collectors FPSC were studied due to their simplicity, low maintenance, and cost-effectiveness. The study focused on comparing FPSC thermal performance using CuOH2O nanofluids. Experiments were conducted over three months during the Iraqi weather conditions January, February, and March with carefully selected nanoparticle concentrations. Data was collected from 9 A.M. to 3 P.M., using various mass flow rates ranging from 0.003 to 0.076 kgs. Results showed a direct correlation between temperature and nanoparticle concentrations, with the highest outlet temperature 50C observed at 3 P.M. for 1 CuO-water nanofluid. Notably, at 1 P.M. in March, the 1 CuO-water nanofluid exhibited a 32 increase in collector thermal efficiency, surpassing pure water by 11.3. This would improve the performance of FPSC by achieving higher efficiency increments. These improvements were attributed to the unique physical properties of nanoparticles, their increased surface area, and higher thermal conductivity. The study determined that the optimum nanofluid concentration for superior collector efficiency was 1.

 In this research, flat plate solar collectors FPSC were studied due to their simplicity, low maintenance, and cost-effectiveness. The study focused on comparing FPSC thermal performance using CuOH2O nanofluids. Experiments were conducted over three months during the Iraqi weather conditions January, February, and March with carefully selected nanoparticle concentrations. Data was collected from 9 A.M. to 3 P.M., using various mass flow rates ranging from 0.003 to 0.076 kgs. Results showed a direct correlation between temperature and nanoparticle concentrations, with the highest outlet temperature 50C observed at 3 P.M. for 1 CuO-water nanofluid. Notably, at 1 P.M. in March, the 1 CuO-water nanofluid exhibited a 32 increase in collector thermal efficiency, surpassing pure water by 11.3. This would improve the performance of FPSC by achieving higher efficiency increments. These improvements were attributed to the unique physical properties of nanoparticles, their increased surface area, and higher thermal conductivity. The study determined that the optimum nanofluid concentration for superior collector efficiency was 1.

 In this research, flat plate solar collectors FPSC were studied due to their simplicity, low maintenance, and cost-effectiveness. The study focused on comparing FPSC thermal performance using CuOH2O nanofluids. Experiments were conducted over three months during the Iraqi weather conditions January, February, and March with carefully selected nanoparticle concentrations. Data was collected from 9 A.M. to 3 P.M., using various mass flow rates ranging from 0.003 to 0.076 kgs. Results showed a direct correlation between temperature and nanoparticle concentrations, with the highest outlet temperature 50C observed at 3 P.M. for 1 CuO-water nanofluid. Notably, at 1 P.M. in March, the 1 CuO-water nanofluid exhibited a 32 increase in collector thermal efficiency, surpassing pure water by 11.3. This would improve the performance of FPSC by achieving higher efficiency increments. These improvements were attributed to the unique physical properties of nanoparticles, their increased surface area, and higher thermal conductivity. The study determined that the optimum nanofluid concentration for superior collector efficiency was 1.

Makale detayları

Evaluation of the thermal efficiency of nanofluid flows in flat plate solar collector

Yazarlar:

N.A.

Yayıncı:

Yildiz Technical University

Ana Başlıklar:

Thermodynamics and Statistical Physics

Dergi:

Journal of Thermal Engineering Vol.10 Issue 2, pp.299-307

Belge Tipi:

Makale

Yayın Tarihi:

3/2024

Belge Dili:

İngilizce

Document ID (Org No.):

2001313850

pISSN:

2148-7847

Copper Oxide Nanoparticles

Efficiency

Experimental Study

Nanofluid

Thermal Performance

Sayı

Makale detayları

Evaluation of the thermal efficiency of nanofluid flows in flat plate solar collector

Yazarlar: N.A.

Yayıncı: Yildiz Technical University

Ana Başlıklar: Thermodynamics and Statistical Physics

Dergi: Journal of Thermal Engineering Vol.10 Issue 2, pp.299-307

Belge Tipi: Makale

Yayın Tarihi: 3/2024

Belge Dili: İngilizce

Document ID (Org No.): 2001313850

pISSN: 2148-7847

Copper Oxide Nanoparticles

Efficiency

Experimental Study

Nanofluid

Thermal Performance

Sayı

Yazarlar:

N.A.

Yayıncı:

Yildiz Technical University

Ana Başlıklar:

Thermodynamics and Statistical Physics

Dergi:

Journal of Thermal Engineering Vol.10 Issue 2, pp.299-307

Belge Tipi:

Makale

Yayın Tarihi:

3/2024

Belge Dili:

İngilizce

Document ID (Org No.):

2001313850

pISSN:

2148-7847